TS400 Available Now

Nine Reasons to Buy  Stihl TS400

Common Terms

Standard Features of the STIHL Cutquik® Cut-Off Machines

Nine Important Reasons Why You Should Buy a STIHL Cutquik®.

 

	#1 Endurance Work longer with superior power to weight. The STIHL TS 400 is equipped with a 64.1 cc engine that provides 4.4 bhp. The 12 " model weighs only 20.8 lbs.
	#2 Dependability The 3-stage air filtration system is 99.96% effective in filtering dust particles and other wearing agents before reaching the engine.
	#3 Performance The IntelliCarb™ compensating carburetor system maintains the correct fuel-to-air ratio allowing the engine to run at full RPM, even when the filter is significantly clogged.
	#4 Reliability This cooling system features a large air intake area, a large flywheel and 19 thin cylinder fins for superior air flow and heat dissipation.
	#5 Smooth EasyStart® system with ElastoStart™ shock-absorbing starter handle and decompression valve noticeably reduces starter rope jerkback and operator fatigue.
	#6 Durability The easy-to-use semi-automatic belt tensioner adjusts the belt with one turn of a wrench. It helps prevent premature v-belt wear due to over-tensioning. (Models TS 400 and TS 460 only.)
	#7 Comfort The anti-vibration system features five buffer elements that absorb vibrations from the engine, therefore reducing vibration transmitted to the operator.
	#8 Versatility The reversible cutting arm helps make cuts closer to the wall or ground. Arm changes from inboard to outboard in just a few minutes.
	#9 Convenience The throttle trigger, throttle trigger interlock, and Master Control Lever™ (start/run/off) functions are all integrated into the handle and easy to operate while wearing gloves. (Models TS 400 and TS 460 only.)

COMMON TERMS

STIHL Cutquik®

Adjusting Lever of Wheel Guard: To adjust the guard in a way that directs the cutting debris away from the operator.

Clutch: Couples engine to the V-belt pulley when engine is accelerated beyond engagement speed.

Wheel: Can either be a composite abrasive wheel or a diamond.

Eccentric Adjuster: For tensioning the V-belt on models TS 510, and TS 760.

Front Handle: Handle bar for the left hand at front of cut-off machine.

Semi-Automatic Adjuster: For tensioning the V-belt on models TS 400 and TS 460.

Thrust Washer: Distributes clamping pressure of mounting bolt evenly over wheel.

Wheel Guard: Partially covers the wheel and deflects abrasive debris away from the operator.

Wheel: Abrasive disc used to cut the material. There are two basic types - composite and diamond.